Dismantle and Assemble of Motors

Dismantle and Assemble of Motors Points : Dismantle and Assemble of Motors Dismantle Always remember these points, when you are starting to dismantling of a motor.

1. First of all, remove the pully of motor on the shaft, also remove the fan cover and then open the fan, which is screwed on the shaft of motor for cooling purpose.
2. The shaft or pully of the motor is always in front of your eyes and then you mark a line on the did covers and on the yoke. The advantage of this line is that, when you closing the motor you easily meet these mark points and close the motor cover.
3. Open the nut-bolts or screws of the end-covers of the motor by using spanner or screw driver.
4. Two screw drivers are inserted in motor cover and apply a little pressure internally as a result, the cover of the motor is easily opened.
5. After that, the rotor of the motor is easily come out.
6. The back side and cover of the motor are removed, by using the method, which are mentioned in point (4).
7. The bearings of the motor are dip into kerosene oil and then apply the grease into the bearings.
8. Clean the stator of the motor carefully.

Assemble

1. First of all, the end cover of the motor is screwed with the yoke.
2. Enter the rotor of the motor in stator.
3. Fit the rotor in exact position in stator and then screwed the front cover of the motor.
4. The cooling fan of the motor is screwed on the shaft.
5. In last, tight the cover of the cooling fan with the yoke of the motor.