Remember these important points, when you make the connections of a sub-circuit of the motor.
(1) Always use the fuses or circuit breaker in sub-circuits of the motor.
(2) Always use the start and stop buttons in motor circuit, a controller is also used, because it isolates the motor from supply. In motor starter circuits relays must be used because it protects the circuit against overloading. A under voltage protection is also used with motor circuit.
(3) The value of volt-drop is not exceeding to 5% in controlling and protecting devices and cables of the motor.
(4) The rating of the final sub circuit is 15A. We can also derive the-more than one motor on the final sub circuit but the total load of the motor always remains less than 15A:
(5) The Motors, whose current ratings are greater than 20 or equal to 20, are always derive with distribution fuse board, where fuses and circuit breaker are installed.
In this circuit three blocks are shown, in first block sub-circuit protection is marked, in second isolator is marked and in third starter is marked. Now, we study about each section one by one.
No comments:
Post a Comment